What should engineers review before using TPS62004DGSR?

Verify that the source remains within the 2 V to 5.5 V operating range, that the required load is supported at the lowest VIN, and that the recommended inductor, capacitor, grounding, and current-limit connections are used.

What is the pinout of TPS62004DGSR?

Use the TPS62004DGSR datasheet for the official pinout diagram and pin names. In PartGenie, ask Datasheet AI about TPS62004DGSR pinout to locate pins, power rails, and interface signals before layout.

TPS62004DGSR Datasheet, Specs, Alternatives & ECAD | Texas Instruments

AI summary

TPS62004DGSR is a fixed 1.5 V synchronous buck regulator for 2 V to 5.5 V rails, with up to 600 mA output capability and a 10-pin VSSOP package.

Best for

1.5 V low-power rails
Battery-powered electronics
Compact synchronous buck conversion

Avoid if

Input voltage may exceed 5.5 V
A regulated output above the available input voltage is required
The load requires more than the supported output capability at minimum VIN

Check before use

Use a 10 uH inductor; values below 10 uH or above 22 uH may cause stability issues.
Use at least 10 uF input capacitance and the output-capacitor requirement applicable to the output voltage.
Tie ILIM to GND for the lower typical current limit or VIN for the higher typical limit.