What should engineers review before using YSFP2014S-150M?

Check peak current against the 18 A typical saturation-current condition, which is specified at about 30% inductance reduction. Check RMS current against the 16 A rating at approximately 40°C temperature rise, and confirm that total part temperature remains below 125°C.

What is the pinout of YSFP2014S-150M?

Use the YSFP2014S-150M datasheet for the official pinout diagram and pin names. In PartGenie, ask Datasheet AI about YSFP2014S-150M pinout to locate pins, power rails, and interface signals before layout.

YSFP2014S-150M Datasheet, Specs, Alternatives & ECAD | YJYCOIN(益嘉源)

AI summary

YSFP2014S-150M is a 15 µH high-current SMD power inductor rated for 16 A RMS and 18 A typical saturation current. It is intended for low-profile DC/DC power stages where low DCR is important.

Best for

High-current DC/DC converter output filters
Distributed power rails
Battery-powered high-current regulators

Avoid if

Applications requiring a specified RoHS, REACH, MSL, or lifecycle declaration
Designs without sufficient board area or thermal validation

Check before use

Verify worst-case peak current and inductance derating
Validate temperature rise in the finished assembly
Confirm the recommended PCB land pattern and mechanical clearance

Key specifications

Inductance: 15 µH ±20%
DCR, maximum: 9.5 mΩ
Saturation current: 18 A typ. at approximately 30% inductance drop
RMS current: 16 A at approximately 40°C temperature rise
Operating temperature: -40°C to +125°C
Maximum dimensions: 21.5 mm × 22.5 mm × 14.5 mm

Application

DC/DC convertersHigh-current power suppliesDistributed power systemsFPGA power rails

Where to Buy

Real-time and catalog pricing from verified distributors

Alternative components

Alternatives are being enriched. Analyze this part in PartGenie for the latest matches.

Design and risk insights

Questions & answers

YSFP2014S-150M is a YJYCOIN high-current surface-mount power inductor in the YSFP2014S series. Its nominal inductance is 15 µH with ±20% tolerance.